So last night we went to the London hackspace with an EPS file and a lot of hope.
The plan…
Lasers!
Can you tell what it is yet?
Next of course was to start on the kegerator.
For most kegerators, you need to lots of complicated things. We decided to keep it very simple and try to keep the fridge as insulated as possible. The gas (CO2) is kept outside and fed in through the top of the fridge.
This conduit we got for another project was perfect for 3/8 beer line. It can take two lines in each section. The plan is to run a gas line in from outside and the beer out. We have one beer line for the handpump, two for a font (yet to buy).
Siliconed in!
Just needs a clean!
And a spray… remember that laser cutter at the start?
Won’t lose these easily!
Sprayed all the things!
And soon to come, a pump clip! 🙂
Leave a Reply